Home :: STEEL SPACERS

STEEL SPACERS

Block Division's steel spacers are machined from solid bar stock.  These products are a necessity for any pulley system.  Take a look at our selection of steel spacers which could increase the median load on any application.

Block Division’s steel spacers are used on sheaves with the following model numbers: 00158, 00208, 00258, 00308, 00358, 00408, and 00508.  They are made from mild steel and used to replace or reduce the factory specified ID (shaft size) to an ID needed. For example, the 00158 through 00308 sheave have an ID of ½ inch, and the model number 05014 steel spacer reduces that to ¼ inch, the model number 05516 steel spacer reduces to 5/16 inch, and the 05038 to 3/8 inch. The 00358, 00408 and 00508 have an ID of ¾ inch, and the steel spacer model number 07538 would reduce the ID to 3/8.

Have questions regarding steel spacers? Give Block Division a call!

SPECIFICATIONS CHART

Model No. A B C
05014
Order
1/4"6 mm 1/2"13 mm 1/2"13 mm
05038
Order
3/8"10 mm 1/2"13 mm 1/2"13 mm
05516
Order
5/16"8 mm 1/2"13 mm 1/2"13 mm
07538
Order
3/8"10 mm 3/4"19 mm 3/4"19 mm